HTS - Hawke Transit System Block, Frames and Accessories, Round Transit Frames - HRT, Civil Transit Frames - HCX and Marine Transit Frames - HMX. Cable Systems supply Cable Glands and other electrical products including Hawke EExe certified junction boxes to suit the customers requirements whilst still retaining certification. This is endorsed and backed by Hawke Cable Glands Limited, which offers customers a fast lane service for this product. This service is also available on industrial enclosures. In doing this, we have had to obtain certification by the Electrical Equipment Certification Service (EECS) for the Stockist Assembler Scheme. This was attained in 1994 and allows ourselves to issue our own Licence with the BASEEFA certificate.

HTS - Hawke Transit System

Round Transit Frames - HRT

Installation Guide

Round Transit Frames - HRT | HRT Round Transit Frame Dimensions | HRT Round Transit Installation Guide | HRT Round Transit Design Template | HRT Accessories

The following diagrams explain step by step how easy it is to install Hawke cable/pipe tolerant blocks into round transit frames.


1. Draw up a Hawke design template to determine your cable/pipe layout.	2. Measure the inside of the pipe or aperture to ensure that it is within the tolerance of the round transit frame to be used.	3. Insert the round transit frame and open the two front plates. No lubricant should be applied to the aperture or outside of the frame.

4. Pull the cables or pipes through the frame (note: use open ended round transit to fit around existing cables/pipes).	5. Lubricate the inside of the frame and each of the insert blocks.	6. Begin packing the transit frame starting at the bottom and finishing at the top. Ensure that the blocks are pushed firmly against the rear retaining lip.

7. Slide the two front plates together and tighten the nuts 2mm each time, applying equal pressure to both plates. The bolts should be tightened until the cables/pipes are sealed. A minimum of 10mm of thread should protrude on each bolt.	Hawke's unique colour coding system enables the installation to be visually inspected after completion and ensures the correct matching of the block halves.	Extraction of System Extraction is achieved by releasing the compression, i.e. by reversing steps 5 and 6 and screwing m8 bolts (not supplied) into the threaded holes at each corner of the front plates. This releases the assembly from the aperture and allows the system to be disassembled.
Hawke cable/pipe/block selection gauge	1.Simply wrap the gauge tightly around the cable or pipe from the measurement line.	2. Reading along the measurement line will reveal the correct block size for the cable or pipe and identify it by colour code. e.g. 4022 red where there is an overlap between two block sizes e.g. 6052 or 9053, either size can be selected to best use the available space in the transit frame.